Number Plate Fixing Kit

Hot

Number Plate Fixing Kit

£???

This universal number plate fixing kit contains a selection of components to fit new number plates to any standard vehicle, contains screws and sticky pads.

SKU: nc207 Category:
Log-In & Buy
  • Description
  • Additional information
  • Reviews (0)

Description

Our universal number plate fixing kit contains enough fixings to fit a new number plate to any standard vehicle. A full breakdown of the included components can be found below.

  • 8 Adhesive Pads
  • 6 Screws
  • 8 Screw Caps
    • 2 White
    • 2 Yellow
    • 4 Black
  • 8 Bolts
    • 2 White
    • 2 Yellow
    • 4 Black
  • 6 Nuts (black)
Using Sticky Pads
Sticky Pads in use on a number plate

To use the sticky pads, First remove your old plates and clean the area with a mild detergent or white spirit and let this dry or evaporate. Stick three pads to the rear of the new number plate spacing them equally, typically people use a pad one either end and one in the middle. Pull the backing tape off the adhesive pads and line up the plate near where you want it to be. When you’re happy push it firmly into place, hold it for a few seconds taking care to keep it level and still.

If you just want to buy sticky pads to fit number plates with, you’ll find we provide two choices with 100 or 1000 adhesive pads.

Screws or Bolts

New number plates don’t come with pre-drilled holes, this is because there’s no standard place or spacing used among vehicle manufacturers. To use the screws or nuts and bolts you will need to make a template of the fixing area complete with drilling locations. The old number plate being replaced is perfect for this, draw the plate out on paper and mark the drilling holes. Place this on the new plate and scour or draw the drilling locations onto its front. Start with a small 3mm bit and carefully drill from the front to the back of the plate, match the coloured screw caps with the holes location on the plate and fix to the vehicle. Larger holes will need drilling to use larger screws or the nuts and bolts.

Additional information

Weight 0.25 kg
Dimensions 100 x 60 x 5 mm

Reviews

There are no reviews yet.


Be the first to review “Number Plate Fixing Kit”