50 9x7in ZEV Badge Film

Our 9×7 ZEV Badge Film sheets are UV stable for colour fastness and highly durable. Moreover, each sheet comes with a green side badge showing the plain ZEV Flash on the bottom left side. And don’t forget to set up your plates software to accommodate the pre-printed badge.

• Size: 9×7 inch / 229x178mm – Motorcycle
• Style: Green ZEV Badge
• Position: Half Height at Bottom Left
• Pack: 50 Clear Film Sheets
• Printable: Yes
• Film Plates: Laminate to Motorcycle ABS Plates.
• 3-Part: Match with Motorcycle Clear Acrylic & Wet Reflective.

This item comes in a packs of 50 film sheets, pre-printed with a green side badge. Because it’s pre-printed, you will not need to use a white badge panel. And our ZEV designs are road legal when used on UK roads. But remember green number plates can only displayed on Zero Emission Vehicles.

Our Clear Film sheets make Film and 3-Part Number Plates. Both methods are covered by our British Standard certification, but only when you follow our specification. Which means laminating it to a 3mm ABS plate, or between acrylic & wet reflective for 3-Part.

For more information on standards, regulations and our testing regime, check out our main site and the number plates pages or knowledge base.

Whenever you make a printed number plate, we recommend using a jig and roller for a professional finish.

Film Plates

• Use the pins and place your rigid ABS Plate, face up on to the jig.
• Fold back a few centimetres of the adhesive cover at the end of the plate.
• Next, line up your Clear Film sheet on top, with the printed side facing downwards.
• Carefully join the components together at the Exposed Adhesive edge.
• Ensure both the edge and sides are correctly lined up before joining together.
• Now slide the two parts towards the Rollers at the end of the jig.
• Slowly Wind the arm so the components are fed through, keeping hold of the folded adhesive cover.
• This will remove the adhesive cover and Bond the two parts together.

3-Part Plates

• Place your Clear Film sheet, printed face up on the roller jig.
• Fold back a few centimetres of the adhesive cover at the end of an Acrylic Face.
• Position the Acrylic above the Film, Adhesive Side Down and carefully join the two pieces together
• Leading with the joined edge, keep hold of the Fold and slowly wind the arm & Feed the parts through the roller.
• This will remove the adhesive cover and bond the two parts together.
• Next, put a Wet Reflective adhesive face up on the jig, folding back part of its cover.
• Position the parts joined earlier on top with the Film Facing Down, join them together at the exposed edge
• Once again Feed them through the rollers, keeping hold of the folded adhesive cover.
• Finally, remove the final protective cover from the Acrylic Face.