OKI C532 Transfer Belt
This is an original and genuine OKI C532 Transfer Belt with a life cycle of approximately 60,000 A4 pages before it needs replacing.
OKI Model: 46358502
- Additional information
- SKU/Part No: oki46394902
- Yield: 60,000 A4 Pages
- Brand: OKI
- Genuine: Yes
- For: OKI C532 Printers
This OKI C532 Transfer Belt is compatible with our c532 number plate printer. And it’s made to be simple to install and give you reliable print results. Moreover, it comes with an impressive life cycle of 60,000 A4 pages before it needs replacing. For other C532 printer consumables browse our shops OKI C532 pages.
As a genuine consumable, this transfer belt is guaranteed to work perfectly with our C532 number plate printer. In fact just like our plate media, it is manufactured to meet exacting specifications. And this reliability is a vital part of our BSAU145e certification. Which is why using compatible consumables may effect your number plates legality.
So if you’re printing road legal number plates – only use Genuine Consumables.
Replace a OKI C532 Transfer Belt
Installing a replacement transfer belt is easy, just follow the simple steps below. Or for more help, try our knowledge base articles on the OKI C532 Printer. The instructions that follow assume you are directly facing the front of your OKI printer.
The belt moves toner from the drums onto your media before the fuser bonds it to the surface. Despite having a large life cycle, eventually it will wear out and notify you on the control panel. This is when you need to order a replacement if you don’t have one. The message will change and prompt you to replace it once it is finished, it may even stop printing.
Step 1: Remove the Drums & Toners
To reach the belt, you have to remove all the image drums.
Open up your printers top cover to reveal its innards. Locate the image drums and take them out the printer. To remove one, simply pull the drum unit straight up out of the printer. Now put it aside for reinserting later.
Step 2: Replace the Transfer Belt
First remove the used belt by pulling the blue rings located on both sides towards you. Now lift it all the way out of the printer and put it aside.
Next remove all the packaging from your replacement unit, take care not to touch its surface. Carefully angle & lower it into the printer, holding the blue rings. Then when it’s in position, lock it in place by pushing the blue rings away from you.
Step 3: Replace the Toners & Drums
Now the news belt’s in, replace all the image drums.
One by one replace the drum and toner units back into the printer. To ensure you place them correctly, simply match the labels on the toner with those inside the printer. Finally, close up so your printer can detect the new belt unit.
|Dimensions||378 × 374 × 167 mm|